Step

Action

Yes

No

DEFINITION: Noise originating from the HVAC module assembly.

Were you sent here from Symptoms or another diagnostic table?

Go to Step 2

Go to Diagnostic System Check - Vehicle .

1. Start the engine.
2. Cycle through all of the following:

•	Blower motor speeds.

•	HVAC modes.

•	Temperature control settings.

3. Determine the type of noise:

•	Scrape, pop.

•	Tick/click, chirp or groaning.

•	Air rush/whistle.

Is a scrape or pop noise evident when selecting modes or temperature settings?

Go to Step 6

Go to Step 3

Is a tick/click, chirping, groaning or scraping noise present, but decreases as blower motor speed is decreased?

Go to Step 6

Go to Step 4

Is an air rush/whistle noise evident in all modes but not all temperature settings?

Go to Step 6

Go to Step 5

Is an air rush/whistle noise evident only in defrost or floor mode?

Go to Step 6

Go to Step 6

Remove the I/P carrier. Refer to Instrument Panel Retainer Replacement .

1. Inspect the air flow doors for correct operation.
2. Inspect the ducts for obstructions or foreign materials.

Were any of these conditions found?

Go to Step 9

Go to Step 7

Inspect the mode and temperature doors and seals for warping or cracking.

Are the doors in normal condition?

Go to Step 10

Go to Step 8

Replace the appropriate door and/or seals.

Is the repair complete?

Go to Step 10

--

Remove any obstructions or foreign material found.

Is the action complete?

Go to Step 10

--

Install the I/P carrier. Refer to Instrument Panel Retainer Replacement .

Is the action complete?

Go to Step 11

--

Operate the system to verify the repair.

Did you find and correct the condition?

System OK

Go to Step 2