GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Holden 🢒 2009 🢒 WM Sedan 🢒 Engine 🢒 Engine Controls and Fuel - 2.8L, 3.0L, 3.2L, or 3.6L 🢒 Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake

Removal Procedure
  1. Turn the ignition OFF.

    2. Important: Do not disconnect the power steering fluid lines/hoses from the reservoir.

  2. Remove the power steering fluid reservoir bolts and reposition the power steering fluid reservoir in order to provide access. Refer to Power Steering Fluid Reservoir Replacement .

    3. Object Number: 1949776 Size: SH
  3. Remove the camshaft position (CMP) sensor electrical connector (1) from the CMP sensor (2).

    4. Object Number: 1949777 Size: SH
  4. Remove the the CMP sensor to engine front cover retaining bolt (1).
  5. Remove the CMP sensor (2) from the engine front cover.

Installation Procedure

    Object Number: 1949777 Size: SH
  1. Install the CMP sensor (2) to the engine front cover.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the CMP sensor to engine front cover retaining bolt (1).

    3. Tighten
    Tighten the bolt to 10 N·m (89 lb in).


    Object Number: 1949776 Size: SH
  3. Install the CMP sensor electrical connector (1) to the CMP sensor (2).
  4. Install the power steering fluid reservoir. Refer to Power Steering Fluid Reservoir Replacement .