GM Service Manual Online
For 1990-2009 cars only

HVAC Control Module Replacement LHD

  1. Remove the glove box assembly. Refer to Instrument Panel Compartment Replacement

  2. Object Number: 1958818  Size: SH
  3. Locate the HVAC control module (1) on the HVAC, passenger side near the A pillar.
  4. Disconnect the electrical connectors (2) from the HVAC control module (1).

  5. Object Number: 1958821  Size: SH
  6. Remove the HVAC control module (2) to the HVAC unit retaining screws (1).
  7. Remove HVAC control module (2).

Installation Procedure

  1. Install the HVAC control module (2).

  2. Object Number: 1958821  Size: SH
  3. Install the HVAC control module (2) to the HVAC unit retaining screws (1).

  4. Object Number: 1958818  Size: SH
  5. Install the electrical connectors (2) to the HVAC control module (1).
  6. Install the glove box assembly. Refer to Instrument Panel Compartment Replacement
  7. Important: The HVAC control module is provided as a spare part in "Plant Mode". Configuration and Calibration will have to be down loaded from Tech - 2 and the electric actuator operating ranges will have to be learned. Failure to carry out the configuration will result in DTC’s being set and non function of the HVAC mode postions.

HVAC Control Module Replacement RHD

Removal Procedure

  1. Remove the glove box assembly. Refer to Instrument Panel Compartment Replacement .
  2. Remove left side floor duct. Refer to Floor Air Outlet Duct Replacement - Left Side .

  3. Object Number: 1958804  Size: SH
  4. Locate the HVAC control module (1) on the left side of the HVAC module assembly (2).

  5. Object Number: 1958886  Size: SH
  6. Disconnect the HVAC control module electrical connectors (1 - 3).

  7. Object Number: 1958805  Size: SH

    Important: Make sure the HVAC control module electrical connectors are disconnected before removing the HVAC control module to HVAC module assembly retaining screws (1). The HVAC control module to HVAC module assembly retaining screws (1) contact the HVAC control module (2) circuit board and can short on removal.

  8. Remove the HVAC control module to HVAC module assembly retaining screws (1).
  9. Remove HVAC control module (2).

Installation Procedure


    Object Number: 1958804  Size: SH
  1. Install the HVAC control module (1) to the HVAC module assembly (2).
  2. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1958806  Size: SH

    Important: The HVAC control module to HVAC module assembly retaining screws (1 - 4) should be tightened in the sequence shown to prevent damage to HVAC control module circuit board.

  3. Install the HVAC control module to HVAC module assembly retaining screws (1 - 4).
  4. Tighten
    Tighten the screws to 2 N·m (18 lb in).


    Object Number: 1958886  Size: SH
  5. Connect the electrical connectors (1 - 3) to the HVAC control module.
  6. Install left side floor duct. Refer to Floor Air Outlet Duct Replacement - Left Side .
  7. Install the glove box assembly. Refer to Instrument Panel Compartment Replacement .
  8. If re-programming is required. Refer to Control Module References .
  9. Perform HVAC system relearn. Refer to HVAC Control Module Programming and Setup .