For 1990-2009 cars only
- Install the flexplate (1).
- Install the J 42386-A J 42386-A (1), using the two starter motor to cylinder block retaining bolts (2).
- Install the NEW flexplate to crankshaft retaining bolts.
Important: The flexplate (1) will not initially seat against the crankshaft flange, but will be pulled onto the crankshaft by the flexplate to crankshaft retaining bolts (2). This procedure requires a 3 stage tightening process.
Notice: Refer to Fastener Notice in the Preface section.
Important: Make sure the teeth of the J 42386-A J 42386-A (1) engage correctly with the ring gear teeth, before tightening the flexplate bolts.
Tighten
| • | Tighten a first pass in sequence to 20 N·m (15 lb ft). |
| • | Tighten a second pass in sequence to 50 N·m (37 lb ft). |
| • | Tighten a final pass in sequence to 100 N·m (74 lb ft). |
