GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Holden 🢒 2007 🢒 VE Sedan 🢒 Suspension 🢒 Suspension General Diagnosis 🢒 Stabilizer Shaft Link Replacement

Removal Procedure

    Caution: Refer to Safety Glasses Caution in the Preface section.

    Caution: Refer to Vehicle Lifting Caution in the Preface section.

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.

    2. Object Number: 1958989 Size: SH

    Important: Nuts with micro-encapsulated thread sealant must be discarded after removal.

  2. Remove the stabiliser bar link to stabiliser bar retaining nut (1).

    3. Discard the nut.

  3. Disconnect the stabiliser bar link (3) from the stabiliser bar (2).
  4. Remove and the stabiliser bar link to lower control arm retaining nut (5).

    5. Discard the nut.

  5. Remove the stabiliser bar link (3) from the lower control arm (4).
  6. Remove the stabiliser bar link (3).
  7. Inspect all parts for wear and damage.

Installation Procedure

    Object Number: 1958989 Size: SH
  1. Connect the stabiliser bar link (3) to the stabiliser bar (2).

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the stabiliser bar link to stabiliser bar NEW retaining nut (1).

    3. Tighten
    Tighten the nut to 50 N·m (37 lb ft).

  3. Install the stabiliser bar link (3) to the lower control arm (4).
  4. Install the stabiliser bar link to lower control arm retaining NEW nut (5).

    5. Tighten
    Tighten the nut to 50 N·m (37 lb ft).

  5. Remove the safety stands.
  6. Lower the vehicle to the ground.