Test Description
The numbers below refer to the step numbers on the diagnostic table.
-
This step tests the sunroof switch low reference circuit for an open.
-
This step tests the sunroof switch data 6 circuit for a short to ground.
-
This step tests the sunroof motor control circuits for a short to ground or an open.
Step | Action | Values | Yes | No |
|---|---|---|---|---|
Schematic Reference: Sunroof Schematics . Connector End View Reference: Component Connector End Views . | ||||
1 | Did you perform the Diagnostic System Check - Vehicle? | -- | Go to Step 2 | |
2 | Attempt to operate the power sunroof through its full range of functions in order to verify that the power sunroof inoperative fault is present. Does the power sunroof operate normally? | -- | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
3 | Inspect the RAP fuse for an open. Is the fuse open? | -- | Go to Step 11 | Go to 4Step 4 |
4 |
Does the resistance measure less than the specified value? | 5 Ω | Go to Step 5 | Go to Step 12 |
5 |
Does the voltage measure within the specified range? | 9-16 V | Go to Step 9 | Go to Step 6 |
6 | Test the sunroof switch data 6 circuit of the sunroof switch for a short to ground. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | -- | Go to Step 22 | Go to Step 7 |
7 |
Does the voltage measure within the specified range? | 9-16 V | Go to Step 8 | Go to Step 13 |
8 | Measure the voltage from the RAP relay switch supply voltage circuit of the sunroof control module harness connector C1 to the ground circuit of the sunroof control module harness connector C1. Does the voltage measure within the specified range? | 9-16 V | Go to Step 15 | Go to Step 18 |
9 | Test the sunroof switch. Refer to Power Sunroof Switch Test . Is the sunroof switch OK? | -- | Go to Step 10 | Go to Step 16 |
10 |
Does the test lamp illuminate when activated to the open and close positions? | -- | Go to Step 17 | Go to Step 14 |
11 | Test the RAP relay switch supply voltage circuit of the sunroof control module for a short ground. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | -- | Go to Step 22 | Go to Step 15 |
12 | Test the sunroof switch low reference circuit of the sunroof switch for an open. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | -- | Go to Step 22 | Go to Step 15 |
13 | Test the RAP relay switch supply voltage circuit of the sunroof control module for an open. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | -- | Go to Step 22 | Go to Retained Accessory Power (RAP) Description and Operation |
14 | Test the sunroof motor control circuits of the sunroof motor for a short to ground or an open. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | -- | Go to Step 22 | Go to Step 15 |
15 | Inspect for poor connections at the harness connectors of the sunroof control module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | -- | Go to Step 22 | Go to Step 19 |
16 | Inspect for poor connections at the harness connector of the sunroof switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | -- | Go to Step 22 | Go to Step 20 |
17 | Inspect for poor connections at the harness connectors of the sunroof motor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | -- | Go to Step 22 | Go to Step 21 |
18 | Repair the open in the sunroof module ground circuit. Refer to Wiring Repairs and Connector Repairs . Did you find and correct the condition? | -- | Go to Step 22 | -- |
19 | Replace the sunroof control module. Refer to Control Module References , for replacement, setup, and programming. Did you complete the replacement? | -- | Go to Step 22 | -- |
20 | Replace the sunroof switch. Refer to Sunroof Switch Replacement . Did you correct the condition? | -- | Go to Step 22 | -- |
21 |
Important: Inspect the sunroof assembly for binding or mechanical failure. Replace the sunroof motor. Refer to Sunroof Motor/Actuator Replacement . Did you complete the replacement? | -- | Go to Step 22 | -- |
22 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 2 |
