Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptors
DTC P0219: Engine Over speed ConditionCircuit/System Description
This DTC is used to indicate that the engine speed exceeded the fuel cutoff limit in gear. This DTC may set if the transmission is placed in a low gear while driving down a steep grade or traveling at a high speed.
Conditions for Running the DTC
| • | The DTC is valid for manual transmissions only. |
| • | The engine is running. |
| • | Ignition voltage is between 10-18 volts. |
Conditions for Setting the DTC
The ECM detects the engine speed is greater than 7,200 RPM for greater than 1 second.
Action Taken When the DTC Sets
DTC P0219 is a type A DTC.
Conditions for Clearing the DTC
DTC P0219 is a type A DTC.
Diagnostic Aids
An over speed condition can only exist when a low gear on a manual transmission is selected and the vehicle is travelling at high road speed. This DTC cannot be set by free revving the engine.
Reference Information
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Note: This DTC is used for information only. This DTC does NOT indicate there is a condition with the crank sensor or the engine control module (ECM).
DTC P0219 is an informational DTC.
Repair Instructions
Perform the Diagnostic Repair Verification
