Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category |
DTC Descriptor
DTC B1008 42: Calibration Data Not ProgrammedCircuit/System Description
When the ignition is ON, the rear object alarm module performs a self[dash ]test to diagnose critical malfunctions within itself. When the rear object alarm module has completed the power-up mode the rear object alarm module will establish communication with the body control module (BCM). During the power-up mode the rear object detection alarm module will check for a valid calibration data set, if no valid calibration set is found the rear object alarm module will set a DTC and command the object detection enable/disable switch indicator OFF.
Conditions for Running the DTC
Ignition voltage is between 9-16 volts.
Conditions for Setting the DTC
This code will set as current when the calibration set does not exist in the rear object alarm module upon start-up.
Action Taken When the DTC Sets
| • | The rear object alarm module sets a DTC. |
| • | No confirmation tone will be heard when reverse gear is selected and hand brake is released. |
Reference Information
Schematic Reference
Connector End View Reference
Electrical Information Reference
Scan Tool Reference
Circuit/System Testing
Ignition ON, using a scan tool check that DTC B1008 is set in history.
| ⇒ | If DTC B1008 is current perform the programming setup. |
Repair Instructions
| • | Perform the Diagnostic Repair Verification . |
