For 1990-2009 cars only
- Fill power steering fluid reservoir with fluid to the COLD MAX level mark on the reservoir.
- Raise the vehicle until the front wheels are off the ground. Refer to Lifting and Jacking the Vehicle.
- With the engine OFF, turn the steering wheel from stop to stop 12 times.
- Verify power steering fluid level per operating specification. Refer to Checking and Adding Power Steering Fluid.
- Start the engine and allow to run at idle for three seconds, turn the engine OFF.
- Repeat steps 4 and 5 until the power steering level remains constant.
- Start the engine and allow to run at idle.
- Rotate steering wheel from left to right 8 times. Check for sign of cavitation or fluid aeration (pump noise/whining).
- Turn the engine OFF. Verify the fluid level. Refer to Checking and Adding Power Steering Fluid.
Important:
• Use approved new power steering fluid from a sealed container. For fluid
specifications refer to
Fluid and Lubricant Recommendations. • Hoses touching the frame, body or engine may cause power steering system
noise. Verify that the hoses do not touch any other part of the vehicle. • Loose connections may not leak, but may allow air into the steering system.
Verify that all hose connections are tight. Refer to
Fastener Tightening Specifications.
Notice: When adding fluid or making a complete fluid change, always use the proper power steering fluid. Failure to use the proper fluid will cause hose and seal damage and fluid leaks.
Important: Power steering fluid level must be maintained throughout bleed procedure.
