Special Tools

Caution: Refer to Gasoline/Gasoline Vapors Caution in the Preface section.




1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Remove the beauty cover. Refer to Engine Cover Replacement .
3. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .



4. Disconnect the fuel inlet/outlet line from the fuel filter.
5. Disconnect the fuel heater and temperature sensor connector (1).
6. Disconnect the water in fuel sensor connector (2).
7. Remove the fuel filter assembly from the bracket by lifting upward.



8. Install EN-48303 and EN-48304 (2) to the fuel filter assembly.
9. Turn EN-48304 (1) counterclockwise.



10. Remove the fuel filter locker (5).
11. Remove the fuel filter cap (4) with the O-ring (1).

Important: Do not reuse the fuel filter element if the element is exposed to the air over a minute.

Important: The fuel filter cap includes the fuel heater and temperature sensor as one body. Also, the fuel filter housing includes the water in fuel sensor as one body.

12. Remove the fuel filter in the fuel filter housing (2).

Important: Do not touch the fuel filter element by hand to prevent fuel contamination.

1. Install the fuel filter into the fuel filter housing (2).
2. Install the fuel filter cap (6) with a new O-ring (1).

Notice: Refer to Fastener Notice in the Preface section.

3. Install the fuel filter locker (5) by using EN-48303 and EN-48304 .

Tighten
Tighten the fuel filter locker to 30 N·m (22.1 lb ft).




4. Install the fuel filter to the bracket.
5. Install the fuel filter bracket to the body.

Tighten
Tighten the fuel filter bracket retaining nut to 10 N·m (88.5 lb ft).