GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Holden 🢒 2008 🢒 Captiva 🢒 Engine 🢒 Engine Cooling 🢒 Transmission Rear Mount Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove both front tires and wheels. Refer to Tire and Wheel Removal and Installation .

    3. Object Number: 927949 Size: SH
  3. If equipped with AWD, disconnect the stabilizer links from the stabilizer shaft.
  4. If equipped with AWD, swing the stabilizer shaft upwards in order to gain additional clearance.

    5. Object Number: 1398176 Size: SH
  5. Remove the transmission mount-to-bracket through bolt.
  6. Remove the transmission mount-to-frame bolts.
  7. Remove the transmission mount from the vehicle.

Installation Procedure
  1. Position the transmission mount to the frame.

    2. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1398176 Size: SH
  2. Install the transmission mount-to-frame bolts.

    3. Tighten
    Tighten the bolt to 50 N·m (37 lb ft).

  3. Install the transmission mount-to-bracket through bolt, while aligning the transmission mount to the bracket.

    4. Tighten
    Tighten the bolt to 110 N·m (81 lb ft).


    Object Number: 927949 Size: SH
  4. If equipped with AWD, lower the stabilizer shaft and connect the stabilizer links .

    5. Tighten
    Tighten the stabilizer link nuts to 65 N·m (48 lb ft).

  5. Install both front tires and wheels. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle.