GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Holden 🢒 2009 🢒 Barina 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Accelerator Pedal Position Sensor Replacement

Removal Procedure

    Warning: Refer to Battery Disconnect Warning in the Preface section.


    Object Number: 1670940 Size: SH
  1. Disconnect the negative battery cable.
  2. Disconnect the electronic throttle control (ETC) connector from the accelerator pedal.
  3. Remove the 3 accelerator pedal retaining nuts.
  4. Remove the accelerator pedal.

Installation Procedure

    Object Number: 1670940 Size: SH
  1. Position the accelerator pedal.

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the 3 accelerator pedal retaining nuts.

    3. Tighten
    Tighten the accelerator pedal retaining nuts to 19 N·m (14 lb ft).

  3. Connect the ETC connector to the accelerator pedal.
  4. Connect the negative battery cable.