GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

    Warning: Refer to Battery Disconnect Warning in the Preface section.


    Object Number: 1241945  Size: SH
  1. Disconnect the negative battery cable.
  2. Caution: Refer to Heated Oxygen and Oxygen Sensor Caution in the Preface section.

    Caution: Do not solder heated oxygen sensor wires. Soldering the wires will result in the loss of the air reference to the sensor. Refer to Engine Electrical for proper wire and connection repair techniques.

  3. Disconnect the electrical connector.
  4. Remove the heated oxygen sensor 2 (HO2S2).

Installation Procedure


    Object Number: 1241945  Size: SH

    Note: A special anti-seize compound is used on the oxygen sensor threads. This compound consists of a liquid graphite and glass beads. The graphite will burn away, but the glass beads will remain, making the sensor easier to remove. New or service sensors will already have the compound applied to the threads. If a sensor is removed from any engine and if for any reason it is to be reinstalled, the threads must have anti-seize compound applied before reinstallation.

  1. Coat the threads of the HO2S2 with an anti-seize compound, if needed.
  2. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the HO2S2.
  4. Tighten
    Tighten the heated oxygen sensor to 42 N·m (31 lb ft).

  5. Connect the electrical connector.
  6. Connect the negative battery cable.