Tools Required

J 45059 Electronic Torque Angle Meter

1. Remove the left or the right valve rocker arm cover. Refer to Valve Rocker Arm Cover Replacement - Left Side or Valve Rocker Arm Cover Replacement - Right Side .



2. Remove the rocker arm bolts.

Important: Place the parts on a clean surface. Store the components in order so they can be reassembled in the same location and with the same mating surfaces as when removed.

3. Remove the valve rocker arms.



4. Remove the push rod guide plates if all the valve rocker arms are removed.



5. Remove the push rods.
6. Clean the push rods, the valve rocker arms, the bolts, and the guide plates.
7. Clean the valve rocker arm bolts of all thread adhesive.

1. Use compressed air in order to blow oil out of the tapped holes in the cylinder head.



2. Lubricate the ends of the push rods with new engine oil.
3. Install the push rods to the same position on the cylinder head.



4. Install the push rod guide plates.



5. Install the valve rocker arms.

Notice: This bolt is designed to permanently stretch when tightened, and therefore MUST be replaced anytime it is removed. The correct part number fastener must be used to replace this type of fastener. Do not use a bolt that is stronger in this application. If the correct bolt is not used, the parts will not be tightened correctly. The system or the components may be damaged.

6. Apply threadlocker to the rocker arm bolt threads. Refer to Adhesives, Fluids, Lubricants, and Sealers for the correct part number.

Notice: Refer to Fastener Notice in the Preface section.

7. Install the valve rocker arm bolts.

Tighten

1. Tighten the bolts to 15 N·m (11 lb ft).
2. Use the J 45059 to rotate the bolts an additional 90 degrees.
8. Install the left or the right valve rocker arm cover. Refer to Valve Rocker Arm Cover Replacement - Left Side or Valve Rocker Arm Cover Replacement - Right Side .
9. Inspect the valve train for noise.