GM Service Manual Online
For 1990-2009 cars only

Communication Interface Module Replacement TrailBlazer, Envoy, Bravada, Rainier

Removal Procedure

    Important: The vehicle communication interface module (VCIM) has a specific set of unique numbers that tie the module to each vehicle. These numbers, the 10-digit station identification and the 11-digit electronic serial number, are used by the National Cellular Network and OnStar® to identify the specific vehicle. Because these numbers are tied to the vehicle identification number of the vehicle, you must never exchange these parts with those of another vehicle.

  1. Position the right rear seat bottom to a cargo position.

  2. Object Number: 742196  Size: SH
  3. Remove the protective cover from the vehicle communication interface module (VCIM).

  4. Object Number: 741624  Size: SH
  5. Remove the module from the upper bracket by releasing the retaining tab.

  6. Object Number: 741627  Size: SH
  7. Remove the electrical connectors from the VCIM.
  8. Remove the VCIM from the vehicle

Installation Procedure

  1. If replacing the VCIM, record the 10-digit STID number, and the 11-digit ESN number from the labels on the new module.

  2. Object Number: 741627  Size: SH
  3. Install the module to the upper bracket ensuring the retaining tab is fully seated.
  4. Notice: In order to avoid damage to the circuit board, do NOT over-tighten the thumb screws. Using your fingers, apply only a light pressure.

  5. Connect the 2 electrical connectors.
  6. Tighten
    Tighten the module thumb screw to a maximum of 0.2 N·m (2 lb in).


    Object Number: 742196  Size: SH
  7. Install the protective cover to the module.
  8. Position the right rear seat bottom to a passenger position.
  9. Important: After replacing the vehicle communication interface module, you must reconfigure the OnStar® system. Failure to reconfigure the system will result in an additional customer visit for repair. In addition, pressing and holding the white dot button on the keypad will NOT reset this version of the OnStar® system. This action will cause a DTC to set.

  10. Reconfigure the OnStar® system. Refer to OnStar Reconfiguration .