Preliminary Procedure

Disconnect the lower portion of the seat back finish panel from the seat frame and lift upward to gain access to the screws.

1

Front Seat Back Cushion Filler Panel Screw (Qty: 2)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
2 N·m (18 lb in)

2

Front Seat Back Cushion Filler Panel

Procedure

1. Insert a flat bladed tool between the seatback panel and the seat back cushion frame to release the middle retainer tabs on each side.
2. Pull away from the seat at the bottom edge first and disengage the top of the panel from the seat back frame.

1

Front Seat Back Cushion Finish Panel

Procedure

1. On the right and left sides of the upper portion of the seatback panel, insert a flat bladed tool between the seatback panel and the seat back cushion to release the upper retainer tabs on each side.
2. Push the tool against the tabs to release.
3. Carefully flex the seatback panel outward to slide the top tabs out of the retainer slots.
4. On right and left sides of the lower portion of the seatback panel, insert a flat bladed tool between the seatback panel and the seat back cushion to release the retainer tabs.
5. Carefully pull back on the seatback panel, all released tabs must be clear of all obstructions.
6. Lift up on the panel to remove from the bottom of the seat back frame, using a flat bladed tool to disengage the bottom clips if necessary.