The camshaft position (CMP) actuator system is used for a variety of engine performance enhancements. These enhancements include lower emission output through exhaust gas recirculation (EGR) control, a wider engine torque range, improved gas mileage, and improved engine idle stability. The CMP actuator system accomplishes this by controlling the amount of intake and exhaust valve overlap. For the 6.0 liter (LFA) engine, the park position for the CMP actuator and camshaft is 14.5 degrees after top dead center (ATDC), or 29 crankshaft degrees ATDC. The engine control module (ECM) can only command the CMP actuator to advance the valve timing from the park position, or retard the valve timing back to the park position. The total range of valve timing authority is 23 degrees camshaft rotation, or 46 degrees of crankshaft rotation. The control range is from the park position of 14.5 degrees camshaft, or 29 degrees crankshaft ATDC, to 8.5 degrees camshaft or 17 degrees crankshaft before top dead center (BTDC).

The camshaft position (CMP) actuator system is controlled by the control module. The control module sends a pulse width modulated 12-volt signal to a CMP actuator solenoid in order to control the amount of engine oil flow to a camshaft actuator passage. There are 2 different passages for oil to flow through, a passage for CAM advance and a passage for CAM retard. The camshaft actuator is attached to the front of the camshaft, and is hydraulically operated in order to change the angle of the camshaft relative to crankshaft position (CKP). Engine oil pressure (EOP), viscosity, temperature, engine oil level, and aftermarket engine oil additives can have an adverse affect on camshaft phaser performance.

The engine control module (ECM) monitors the control circuit of the camshaft position (CMP) actuator solenoid for electrical faults. The control module has the ability to determine if a control circuit is open, shorted high, or shorted low. If the control module detects a fault with the CMP actuator solenoid control, DTC P0010 will set.

The engine control module (ECM) monitors the performance of the camshaft position (CMP) actuator system by monitoring the calibrated desired position and the actual position of the camshaft, through the 4X signal of the CMP sensor. If the difference between the actual and the desired position is greater than a calibrated angle for a calibrated amount of time, DTC P0011 will set.