Schematic Reference: Suspension Controls Schematics

1

Did you perform the RTD Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Real Time Damping

Verify the fault is present.

Does the system operate normally?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

1. Install a scan tool.
2. Turn ON the ignition, with the engine OFF.
3. Using a scan tool, access the RTD Special Functions menu and command the SERVICE RIDE CONTROL message OFF.

Does the message go off when commanded?

Go to Step 5

Go to Step 4

Replace the instrument cluster. Refer to Instrument Cluster Replacement in Instrument Panel, Gauges and Console.

Did you complete the replacement?

Go to Step 6

--

Important: After replacement, use the scan tool to perform the set up procedure (re-calibrate) located under Special Functions (F8: Recalibration) for the suspension control module.

Replace the Suspension Control Module. Refer to Electronic Suspension Control Module Replacement .

Did you complete the replacement?

Go to Step 6

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2