Tools Required

Notice: Do not attempt to free the ball stud by using a pickle fork or wedge type tool, because seal or bushing damage could result. Use the proper tool to separate all ball joints.

1. Raise the vehicle.
2. Suitably support the vehicle with jack stands. Refer to Lifting and Jacking the Vehicle in General Information.



3. Remove the idler arm frame bolts and the nuts.
4. Remove the idler arm ball stud nut.

Do NOT reuse the idler arm ball stud nut.

5. Remove the idler arm (17) from the relay rod (10).

Use the J 24319-01 .

6. Inspect the following components:

6.1.	The ball stud threads for damage.

6.2.	The ball stud seal for cuts or other damage.

7. Clean the threads on the ball stud (4).

1. Position the idler arm mounting bracket on the frame.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the frame bolts and the nuts to the idler arm (1).

Tighten
Tighten the frame bolts to 99 N·m (73 lb ft).




3. Install the relay rod (10) to the idler arm ball stud.

Make sure the seal is on the stud.

Tighten
Tighten the J 29193 or the J 29194 to 54 N·m (40 lb ft) in order to seat the tapers.

4. Remove the tool.
5. Install the new prevailing torque nut to the idler arm ball stud.

Tighten
Tighten the nut to 62 N·m (46 lb ft).

6. Lower the vehicle.
7. Adjust the front toe. Refer to Wheel Alignment Measurement in Wheel Alignment.