Rear Wheel Opening Flare Replacement. GMC Truck Yukon

For 1990-2009 cars only

Makes 🢒 GMC_Truck 🢒 2008 🢒 Yukon - 2WD 🢒 Body Hardware and Trim 🢒 Exterior Trim 🢒 Rear Wheel Opening Flare Replacement

Callout	Component Name
1	Rear Wheel Opening Flare Assembly Retainers (Qty: 4)
2	Rear Wheel Opening Flare Assembly Screws (Qty: 4) Notice: Refer to Fastener Notice in the Preface section. Tighten 2 N·m (18 lb in)
3	Rear Wheel Opening Flare Assembly Tip The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength. Clean area where flare will be mounted. Use a suitable solvent, such as flash naphtha or a mix of 50 percent isopropyl alcohol and 50 percent water by volume. Warm body panel with a J 25070 Heat Gun to a minimum 21°C (70°F) prior to flare installation. Do not touch adhesive surface when tape is removed. Peel the tape liner once the flare has been installed and wet out.

Callout

Component Name

Rear Wheel Opening Flare Assembly Retainers (Qty: 4)

Rear Wheel Opening Flare Assembly Screws (Qty: 4)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
2 N·m (18 lb in)

Rear Wheel Opening Flare Assembly

Tip

The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength.
Clean area where flare will be mounted. Use a suitable solvent, such as flash naphtha or a mix of 50 percent isopropyl alcohol and 50 percent water by volume.
Warm body panel with a J 25070 Heat Gun to a minimum 21°C (70°F) prior to flare installation.
Do not touch adhesive surface when tape is removed. Peel the tape liner once the flare has been installed and wet out.