Important: This procedure calls for the replacement of incandescent bulbs only. The light emitting diodes (LEDs) are not replaceable individually. If LED or soldered-in incandescent bulb replacement is needed, send the cluster to an AC Delco Service Center. Refer to Instrument Cluster Replacement .

1. Remove the instrument panel (I/P) cluster. Refer to Instrument Cluster Replacement .



2. Unclip the I/P cluster rear cover plate by prying gently on the tabs with a screwdriver.



3. Remove the rear cover plate from the I/P cluster.



4. Remove the bulb and base assembly by turning the bulb 1/2 turn counter clockwise and pulling outward.
5. Remove the bulb from the base by pulling outward.

Important: This procedure calls for the replacement of incandescent bulbs only. The light emitting diodes (LEDs) are not replaceable individually. If LED or soldered-in incandescent bulb replacement is needed, send the cluster to an AC Delco Service Center. Refer to Instrument Cluster Replacement .

1. Install the bulb to the base.
2. Install the bulb into the cluster by inserting the bulb and base assembly and turning the bulb 1/2 turn clockwise.



3. Carefully snap the rear cover plate to the I/P cluster.
4. Install the I/P cluster. Refer to Instrument Cluster Replacement .