Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Headlights Schematics | |||
1 | Did you perform the Lighting Diagnostic System Check? | Go to Step 2 | |
2 | Turn ON the headlamp switch. Do the headlamps operate normally? | Go to Testing for Electrical Intermittents in Wiring Systems | Go to Step 3 |
3 |
Do the low beams illuminate? | Go to Step 4 | Go to Step 6 |
4 | Connect a test lamp between the ground circuit of the dimmer switch and battery positive voltage. Does the test lamp illuminate? | Go to Step 5 | Go to Step 7 |
5 | Inspect for poor connections at the engine wiring harness junction block and the dimmer switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 9 | Go to Step 8 |
6 | Repair the open in the headlamp dimmer switch low beam signal circuit between the engine wiring harness junction block and the dimmer switch. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 9 | -- |
7 | Repair the open in the headlamp dimmer switch ground circuit. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 9 | -- |
8 | Replace the headlamp dimmer switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column - Tilt or Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column - Standard. Did you complete the repair? | Go to Step 9 | -- |
9 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |
