Rear Object Alarm Module Replacement Yukon XL and Escalade ESV

1. Remove the left rear quarter trim panel. Refer to Rear Quarter Trim Panel Replacement - Left Side.
2. Disconnect the electrical connector from the module.
3. Remove the module fasteners (1).
4. Remove the module (2).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Install the module (2).
2. Install the fasteners (1).

Tighten
Tighten the module fasteners (1) to 1.7 N·m (15 lb in).

3. Connect the electrical connector.
4. Install the left rear quarter trim panel. Refer to Rear Quarter Trim Panel Replacement - Left Side.
5. Refer to Control Module References for programming and setup information.

Rear Object Alarm Module Replacement Cadillac EXT

1. Lift the left rear seat cushion up to gain access to the electronic suspension control module and rear object alarm module container.
2. Remove the cover retainers, discard if damaged.
3. Partially remove the container assembly from underneath the seat.
4. Remove the cover (1) by pushing in on the tabs to release the cover.



5. Disconnect the electrical connector (1) from the rear object alarm module (2).



6. Release the tabs retaining the module to the container (2).
7. Remove the module (1) from the container (2).

1. Install the module (1) to the container (2).



2. Connect the electrical connector (1) to the module (2).



3. Install the container cover (1) and lock in place.
4. Slid the container under the rear seat.
5. Install the container retainers.
6. Set the rear seat to its original position.
7. Refer to Control Module References for programming and setup information.