Differential Side Bearings Replacement All Except 9.75 Inch Axle

Tools Required

1. Remove the differential assembly. Refer to Differential Replacement .



2. Remove the differential side bearings by performing the following steps:

2.1.	For the 8.6 inch and the 9.5 inch axles, install the differential assembly in a vise.

2.2.	For the 10.5 inch axle, place a block of wood on each side of the differential case before installing the differential case into the vise.

Install the differential assembly into a vise.

2.3.	Install the J 22888-20A  (2) and the J 8107-4 , 8.6 inch axle, or the J 36597 , 9.5 inch or 10.5 inch axles as shown.

2.4.	Remove the differential side bearings using the J 22888-20A .

3. Remove the differential assembly from the vise.

1. Install the differential side bearings by doing the following:

1.1.	In order to protect the differential case, install the J 8107-4 , 8.6 inch axle, or the J 36597 , 9.5 inch or 10.5 inch axles, in the case on the side opposite the bearing installation.

1.2.	Install the J 21784 , 8.6 inch axle, or the J 29710 , 9.5 inch or 10.5 inch axle (2), and the J 8092  (1) onto the differential case bearing as shown.

1.3.	Drive the bearing onto the case using the J 21784 or the J 29710 and the J 8092 .

2. Install the differential assembly. Refer to Differential Replacement .

Differential Side Bearings Replacement 9.75 Inch Axle

Tools Required

Removal Procedure

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the differential assembly. Refer to Differential Replacement .



3. Remove the differential side bearing by performing the following steps:

3.1.	Install the J 45711  (2) and the J 36597  (1) as shown.

3.2.	Remove the differential side bearing using the J 45711 and a hydraulic press.

Important: Mark the inboard shims left or right.

4. Remove the inboard shims.

1. Determine the shim thickness and preload for the differential assembly. Refer to Differential Carrier Bearing Preload Adjustment .



2. Install the differential side bearing by doing the following:

2.1.	In order to protect the differential case, install the J 8107-3 in the case on the side opposite of the bearing installation.

2.2.	Install the inboard shims.

2.3.	Install the differential side bearing.

2.4.	Install the J 24430 or the J 45900  (2) and the J 8092  (1) over the differential side bearing.

2.5.	Drive the differential side bearing into position using the J 24430 or the J 45900 and the J 8092 .

2.6.	Install the differential assembly. Refer to Differential Replacement .

3. Fill the axle with lubricant. Use the proper fluid. Refer to Rear Axle Lubricant Replacement .
4. Lower the vehicle.