Tools Required

Important: The front output shaft seal is a two piece internal seal. The inner seal race is a force fit on the front output shaft.

1. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
2. Remove the front propeller shaft. Refer to Front Propeller Shaft Replacement in Propeller Shaft.
3. Insert a flat-tipped screwdriver behind the inner race of the seal.
4. Pry the inner race forward



5. Using a small pry bar, move the inner seal race forward on the front output shaft.
6. remove the inner seal race from the front output shaft.



7. Insert a flat-tipped screwdriver or a small pry bar between the outer lip of the front output shaft seal and the transfer case.
8. Remove the remaining part of the front output shaft seal from the transfer case.

1. Install the J 43484 (2) to the J 8092 (1).
2. Install the seal onto the J 43484 .
3. Using the J 43484 (2) and the J 8092 (1), install the seal.
4. Install the front propeller shaft. Refer to Front Propeller Shaft Replacement in Propeller Shaft.
5. Check the fluid level. Add fluid if necessary.
6. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .