GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2004 🢒 Yukon XL - 4WD 🢒 Driveline/Axle 🢒 Transfer Case - BW 4482-NR4 🢒 Transfer Case Shield Replacement

Removal Procedure

    Object Number: 826834 Size: SH
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. If the vehicle is a 1500 series, remove the transfer case shield bolts, if equipped.
  3. Remove the transfer case shield, if equipped.

    4. Object Number: 396828 Size: SH
  4. If the vehicle is a 2500 series, remove the transfer case shield screws, if equipped.
  5. Remove the transfer case shield, if equipped.

Installation Procedure

    Object Number: 396828 Size: SH
  1. If the vehicle is a 2500 series, position the transfer case shield, if equipped.
  2. Install the transfer case shield screws, if equipped.

    3. Object Number: 826834 Size: SH
  3. If the vehicle is a 1500 series, position the transfer case shield, if equipped.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the transfer case shield bolts, if equipped.

    5. Tighten
    Tighten the bolts/screws to 20 N·m (15 lb ft).

  5. Lower the vehicle.