GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 349061  Size: SH
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the engine shield bolts and shield, if equipped.

  3. Object Number: 750902  Size: SH
  4. Disconnect the camshaft position (CMP) sensor electrical connector (1).

  5. Object Number: 858218  Size: SH
  6. Remove the CMP sensor bolt.
  7. Remove the CMP sensor.
  8. Inspect the CMP sensor for wear, cracks or leakage if the sensor is not being replaced.

Installation Procedure

Important: Inspect the CMP sensor O-ring for wear or damage. If a problem is found, replace the O-ring. Lubricate the new O-ring with engine oil before installing.


    Object Number: 858218  Size: SH
  1. Install the CMP sensor.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the CMP sensor bolt.
  4. Tighten
    Tighten the bolt to 12 N·m (106 lb in).


    Object Number: 750902  Size: SH
  5. Connect the CMP sensor electrical connector (1).

  6. Object Number: 349061  Size: SH
  7. Install the engine shield and bolts, if equipped.
  8. Tighten
    Tighten the bolt to 20 N·m (15 lb ft).

  9. Lower the vehicle.