Endgate Linkage Replacement Pickup

1. Lower the endgate.
2. Loosen the endgate handle bolts. Refer to Endgate Handle Replacement .
3. Raise the endgate.



4. Remove the handle bezel by prying gently on the upper snap-in tabs.
5. Lower and support the endgate.
6. Remove the endgate latch assembly. Refer to Endgate Latch Replacement .



7. Disengage the linkage rod from the latch assembly.



8. Remove the linkage rod (1) from the endgate handle assembly.

1. Install the linkage rod to the endgate handle assembly.



2. Engage the linkage rod (1) to the latch assembly.
3. Install the endgate latch assembly. Refer to Endgate Latch Replacement .
4. Raise the endgate.



5. Install the endgate handle bezel.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

6. Tighten the endgate handle bolts.

Tighten
Tighten the handle bolts to 25 N·m (18 lb ft).