Schematic Reference: Radio/Audio System Schematics

Definition: Volume will not compensate for road speed.

Did you review the Radio/Audio Description and Operation and perform the necessary inspections?

Go to Step 2

Go to Radio/Audio System Description and Operation

1. Turn ON the ignition, with the engine OFF.
2. Turn ON the radio.
3. Turn ON the Speed Compensated Volume (SCV) control located on the radio.
4. Perform a road test of the vehicle at various speeds in order to fully test the SCV. An operative SCV system will adjust the radio volume up as the vehicle speed is increased. Refer to Radio/Audio System Description and Operation for additional information.

Does the system operate normally?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

1. Turn OFF the ignition.
2. Disconnect the radio.
3. Test the vehicle speed signal circuit of the radio for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 6

Go to Step 4

Inspect for poor connections at the harness connector of the radio. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 6

Go to Step 5

Replace the radio. Refer to Radio Replacement .

Did you complete the replacement?

Go to Step 6

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2