Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B0005 00: In Park Signal CircuitDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance | ||||||
|---|---|---|---|---|---|---|---|---|---|---|
Park Enable Relay Control | B0005 | 1 | 1 | -- | ||||||
1. May cause symptom related to the following:
| ||||||||||
Circuit/System Description
The second row power fold and tumble seats and the electronic adjustable pedals (when RPO AN3 Driver Memory Seat is not used) may only operate while the vehicle is in Park. When the body control module detects the vehicle is NOT in park it will enable the Park Enable PCB Relay by providing power to the relay control circuit. When the relay is enabled the electrical power feed to the adjustable pedals and second row power fold and tumble seats is eliminated. Once the vehicle is shifted into Park the BCM will disable the Park Enable PCB Relay and the electrical power feed to the adjustable pedals and second row power fold and tumble seats is enabled.
Conditions for Running the DTC
| • | The system voltage is at least 9.0 V and no more than 16.0 V. |
| • | The DTC will only set when the output is actively being requested by the module. |
Conditions for Setting the DTC
The DTC will set when the module requests the output and there is a short to ground.
Action Taken When the DTC Sets
The module output driver will be shut down and not supply voltage to the circuit.
Conditions for Clearing the DTC
| • | The current DTC will go to history when a malfunction is no longer present. |
| • | The BCM clears the history DTC when a current DTC is not detected in 50 ignition cycles. |
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Electrical Information Reference
Circuit/System Testing
- Ignition OFF, disconnect the park enable PCB relay.
- Connect a test lamp between the park enable signal circuit and battery positive voltage.
- Ignition ON, transmission in PARK, verify the test lamp does not illuminate.
- If the circuit tests normal and the DTC is current, test or replace the park enable PCB relay.
| ⇒ | If the test lamp illuminates, test for a short to ground on the park enable signal circuit. If the circuit tests normal and the DTC is current, replace the BCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for module replacement, setup, and programming |
