For 1990-2009 cars only
Removal Procedure
- Disable the SIR system. Refer to Disabling the SIR System .
- Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement in Doors.
- Loosen the 2 inflatable restraint side impact sensor fasteners (2).
- Remove the inflatable restraint side impact sensor (1) from the door (4).
- Remove the connector position assurance (CPA) (3), and disconnect the inflatable restraint side impact sensor yellow 2-way harness connector (5).
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• Air bag deployment • Personal injury
In order to avoid the above conditions, observe the following guidelines:
• Unnecessary SIR system repairs • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.
Installation Procedure
- Connect the inflatable restraint side impact sensor yellow 2-way harness connector (5) to the inflatable restraint side impact sensor (1).
- Install the CPA (3) to the inflatable restraint side impact sensor yellow 2-way connector (5).
- Install the inflatable restraint side impact sensor (1) to the door (4).
- Install the fasteners (2) to the inflatable restraint side impact sensor (1).
- Install the door trim panel. Refer to Front Side Door Trim Panel Replacement in Doors.
- Enable the SIR system. Refer to Enabling the SIR System .
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Use only hand tools in order to tighten the fasteners to 10 N·m
(89 lb in).
