Notice: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Due to the small clearance between the oil pan and the oil pump screen, jacking against the oil pan may cause the pan to be bent against the pump screen. This will result in a damaged oil pickup unit.

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
3. Remove the wheelhouse panel from the vehicle. Refer to Wheelhouse Panel Replacement in Body front End.
4. For vehicles with 4WD, remove the front propeller shaft. Refer to Front Propeller Shaft Replacement in Propeller Shaft.

Important: DO NOT raise and/or support the engine by the crankshaft balancer, or oil pan.

5. Raise and suitably support the engine using adjustable (screw type) jack stands.



6. Remove the engine mount-to-engine mount bracket bolts. (Right side shown, left side similar).



7. Remove the engine mount bolts.
8. Remove the left engine mount.

1. Install the left engine mount to the engine.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the engine mount bolts to the engine.

Tighten
Tighten the engine mount bolts to 50 N·m (37 lb ft).

3. Lower the engine.
4. Remove the adjustable jack stands.
5. For vehicles with 4WD, install the front propeller shaft. Refer to Front Propeller Shaft Replacement in Propeller Shaft.



6. Install the engine mount-to-engine mount bracket bolts. (Right side shown, left side similar).

Tighten
Tighten the engine mount-to-engine mount bracket bolts to 65 N·m (48 lb ft).

7. Install the wheelhouse panel from the vehicle. Refer to Wheelhouse Panel Replacement in Body front End.
8. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
9. Lower the vehicle.