For 1990-2009 cars only
Circuit Description
At each power up, the transfer case shift control module runs a self-test on the following components:
| • | EEPROM Checksum |
| • | ROM Checksum |
| • | RAM Checksum |
| • | RAM Malfunction |
| • | Relay Malfunction |
Conditions for Setting the DTC
| • | Critical operational parameters, stored in EEPROM, have failed the Checksum test, indicating invalid data. |
| • | The masked ROM code has failed the Checksum test, indicating that masked the ROM data is no longer valid. |
| • | The ROM code has failed the Checksum test, indicating that the ROM data is no longer valid. |
| • | One or more ROM locations have failed the operational tests, indicating that some portions of RAM are not functional. |
| • | The motor circuit test has indicated that one of the modules's relays is not able to make contact. |
Action Taken When the DTC Sets
The SERVICE 4WD indicator lamp will be commanded on and the system will be disabled.
Conditions for Clearing the DTC
| • | Replace the transfer case shift control module. |
| • | Perform the Transfer Case Diagnostic System Check. |
Test Description
The number below refers to the step number on the diagnostic table.
Step | Action | Yes | No |
|---|---|---|---|
1 | Was the Transfer Case Diagnostic System Check performed? | Go to Step 2 | |
Replace the transfer case shift control module. Refer to Transfer Case Shift Control Module Replacement . Is the repair complete? | Go to Step 3 | -- | |
3 |
Does the DTC reset? | -- | System OK |
