Preliminary Procedures

1. Remove the battery. Refer to Battery Replacement .
2. Remove the instrument panel (I/P) upper trim pad. Refer to Instrument Panel Upper Trim Panel with Windshield Defroster Nozzle Grille Replacement .
3. Disconnect the upper intermediate steering shaft. Refer to Upper Intermediate Steering Shaft Replacement .
4. Remove the 4 I/P bolts to body bolts.
5. Disconnect the 5 electrical connections on the passenger side.
6. Pull the passenger side of the I/P back approximately 760 mm (2.5 ft) pivoting on the drivers side . Set on floor or seat.
7. Remove the 2 screws from the HVAC recirculation door and push door towards the center of the vehicle. Refer to Air Inlet Assembly Replacement .
8. Disconnect the coaxial cable at the junction.
9. Insert a shim between the HVAC and side metal approximately 38 mm (1.5 in).
10. Tape pull wire to the coaxial cable.

1

Radio Antenna Mast

Notice: Refer to Fastener Notice in the Preface section.

Tighten
6 N·m (53 lb in)

2

Air Inlet Grille Outer Cover

3

Radio Antenna Assembly Screw (Qty: 3)

Tighten
5 N·m (44 lb in)

4

Radio Antenna Assembly

Tip

1. Remove the cable grommet from the body using the screwdriver from top down.
2. Tie a long wire to the antenna cable to aid in installation of new antenna. Use a screwdriver to guide the cable from the inside.
3. Tape a long pull wire to the antenna cable to aid in installation of the new antenna. Use the screwdriver to guide the wire from the inside.
4. Lubricate the grommet to aid in installation.