Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0569 00: System Configuration ErrorDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
System Disabled Information Stored Invalid Serial Data Received | -- | -- | -- | C0569 00 |
Circuit/System Description
The electronic brake control module (EBCM) is the control center for the ABS TCS/ESP. The programming and calibration needed by the EBCM to control the operation of the ABS TCS/ESP are stored in the EBCMs read only memory (ROM). The EBCM constantly performs a self test that detects, and isolates ABS TCS/ESP faults.
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
The EBCM has not undergone the programming procedure.
Action Taken When the DTC Sets
The driver information center (DIC) displays the SERVICE ABS warning message.
Conditions for Clearing the DTC
A current DTC will clear when the EBCM has undergone the setup procedure.
Diagnostic Aids
A newly replaced EBCM will set DTC C0569 on its initial ignition ON cycle.
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Antilock Brake System Connector End Views
Description and Operation
Electrical Information Reference
Scan Tool Reference
Scan Tool Data List for EBCM
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
