- Install the crankshaft oil deflector.
- Install the crankshaft oil deflector nuts.
- Install clean engine oil into the oil pump through the outlet oil hole. Rotate the pump in both directions to prime and lubricate.
- Assemble the oil pump, driveshaft, and a NEW retainer.
- Install the oil pump assembly.
- Install the bolt attaching the oil pump to the rear crankshaft bearing cap.
- Pour clean engine oil into the oil pump pickup screen.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the crankshaft oil deflector nuts to 50 N·m (37 lb ft).
Important: During assembly, install a NEW oil pump driveshaft retainer. Slightly heat retainer above room temperature for ease of installation onto the oil pump driveshaft.
Position the oil pump onto the locating pins.
Tighten
Tighten the oil pump bolt to 75 N·m (56 lb ft).
