Tools Required

Notice: Refer to Fastener Notice in the Preface section.





Important: Ensure the teeth of the flywheel holding tool engage the engine flywheel teeth.

1. Install the J 42847  (1) to the starter bolt holes.

Tighten
Tighten the J 42847 bolts to 50 N·m (37 lb ft).




2. Remove the crankshaft balancer bolt and washer.



3. Install the J 42846 onto the end of the crankshaft.



4. Install the J 38416-B  (2) in order to remove the crankshaft balancer. Place the legs of the J 38416-B into the recesses cast into the backside of the balancer inner hub.
5. Tighten the center screw of the J 38416-B until the crankshaft balancer is removed from the end of the crankshaft.



6. Remove the J 38416-B .
7. Remove the crankshaft balancer.
8. Remove the J 42846 from the end of the crankshaft.



9. Remove the J 42847  (1).