Tools Required

1. Remove the wiper arms. Refer to Windshield Wiper Arm Replacement .
2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
3. Disconnect the electrical connector from the wiper motor.



4. Remove the 4 bolts retaining the wiper system drive module.



5. Remove the wiper drive system module from the vehicle.



6. Disconnect the drive link from the wiper motor crank arm using the J 39232 .



7. Remove the 2 bolts retaining the wiper motor.
8. Remove the wiper motor from the wiper drive system module.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




1. Install the wiper motor onto the wiper drive system module with the 2 bolts.

Tighten
Tighten the bolts to 8 N·m (71 lb in).




2. Connect the drive link onto the wiper motor crank arm using the J 39529 .



3. Install the wiper drive system module on the vehicle.



4. Install the 4 bolts.

Tighten
Tighten the bolts to 8 N·m (71 lb in).




5. Connect the electrical connector to the wiper motor.
6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
7. Install the wiper arms. Refer to Windshield Wiper Arm Replacement .
8. Operate the wipers and inspect for proper operation.