Step | Action | Yes | No | ||||||
|---|---|---|---|---|---|---|---|---|---|
Schematic Reference: Exterior Lights Schematics Connector End View Reference: Master Electrical Component List | |||||||||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |||||||
2 | Place the hazard switch in the ON position. Do the hazard lamps operate properly? | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 | ||||||
3 | Do the turn signals operate properly? | Go to Step 4 | |||||||
4 |
Does the test lamp illuminate? | Go to Step 5 | Go to Step 7 | ||||||
5 | Test the turn/hazard module signal circuit for an open or high resistance. Refer to Circuit Testing and Wiring Repairs. Did you find and correct the condition? | Go to Step 9 | Go to Step 6 | ||||||
6 | Inspect for poor connections at the turn signal/multifunction switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs. Did you find and correct the condition? | Go to Step 9 | Go to Step 8 | ||||||
7 | Repair the following in the ignition 1 voltage circuit of the turn signal/multifunction switch:
Refer to Circuit Testing and Wiring Repairs. Did you complete the repair? | Go to Step 9 | -- | ||||||
8 | Replace the turn signal/multifunction switch. Refer to Turn Signal Multifunction Switch Replacement. Did you complete the replacement? | Go to Step 9 | -- | ||||||
9 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 2 | ||||||
