GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

    Caution: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.

  1. Raise the vehicle.

  2. Object Number: 10772  Size: SH
  3. Remove the knock sensor wiring harness connector from the knock sensor.

  4. Object Number: 10777  Size: SH
  5. Remove the knock sensor from the engine block.

Installation Procedure


    Object Number: 10777  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. After cleaning the threads thoroughly, install the knock sensor into the engine block.
  2. Tighten
    Tighten the knock sensor to 19 N·m (14 lb ft).


    Object Number: 10772  Size: SH
  3. Install the KS wiring harness connector to the knock sensor.
  4. Caution: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.

  5. Lower the vehicle.