To determine and correct a torque converter vibration, use the following general procedure to achieve the best possible torque converter-to-flywheel balance. Refer to Transmission Replacement for detailed procedure steps as appropriate.

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the battery.
2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
3. Remove the starter motor bolts and position the starter motor aside. Refer to Starter Motor Replacement .



4. Remove the torque converter bolts.



5. Rotate the torque converter one bolt position.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

6. Install the torque converter bolts.

Tighten
Tighten the bolts to 60 N·m (44 lb ft).

7. Install the starter motor and starter motor bolts. Refer to Starter Motor Replacement .

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

8. Connect the battery.
9. Start the vehicle and test for vibration again. If vibration is still present, repeat the testing procedure. Repeat this procedure until you obtain the best possible balance.