GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2008 🢒 Sierra - 4WD 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Clutch Pedal Replacement

Removal Procedure
  1. Move the instrument panel to the service position. Refer to Instrument Panel Service Positioning .

    2. Object Number: 776950 Size: SH
  2. Disconnect the clutch pedal engine start switch electrical connector (1).
  3. Remove the clutch master cylinder. Refer to Clutch Master Cylinder Replacement .

    4. Object Number: 776953 Size: SH
  4. Remove the clutch pedal to clutch pedal bracket bolt .

    5. Object Number: 776952 Size: SH
  5. Remove the clutch pedal to brake module bolts.
  6. Remove the clutch pedal sub-assembly.

Installation Procedure

    Object Number: 776952 Size: SH
  1. Install the clutch pedal sub-assembly.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the clutch pedal to brake module bolts.

    3. Tighten
    Tighten the bolts to 50 N·m (37 lb ft).


    Object Number: 776953 Size: SH
  3. Install the clutch pedal to clutch pedal bracket bolt.

    4. Tighten
    Tighten the bolt to 36 N·m (27 lb ft).

  4. Remove the clutch master cylinder. Refer to Clutch Master Cylinder Replacement .

    5. Object Number: 776950 Size: SH
  5. Connect the clutch pedal engine start switch electrical connector (1).
  6. Install the instrument panel. Refer to Instrument Panel Service Positioning .

    7. Warning: Replacement or reprogramming of the ECM, or replacement of the clutch pedal position sensor (CPPS) or clutch pedal requires that a CPPS learn procedure be performed. Failure to perform the CPPS learn procedure may result in personal injury or damage to the vehicle or its components if the vehicle is in gear and the starter motor is accidentally engaged.

  7. Perform the clutch pedal position sensor learn procedure. Refer to Clutch Pedal Position Sensor Learn or Clutch Pedal Position Sensor Learn .