Callout
| Component Name
|
1
| Transfer Case High/Low Shift Fork Pin
Tip
Drive the pin out using a drift punch and a hammer. |
2
| Transfer Case High/Low Shift Fork
Tip
Inspect for wear or damage in the spring seat locations. The component must be replaced if damage is found. |
3
| Transfer Case High/Low Shift Fork Spring Assembly
Tip
The component must be replaced if the following conditions exist:
| • | The cam lobes are worn or rough. |
|
4
| Transfer Case Two/Four Wheel Drive Actuator Cam Retaining Ring
|
5
| Transfer Case Two/Four Wheel Drive Actuator Cam
|
6
| Transfer Case High/Low Shift Fork - Service - Pin
Tip
| • | Apply a small amount of threadlock GM P/N 12345493 (Canadian P/N 10953488) or equivalent to the shaft of the pin before installation. |
| • | Press the pin into the control actuator shaft using a brass drift until it bottoms. |
|
7
| Transfer Case Shift Fork Shaft Guide Screw
Tip
Apply threadlock GM P/N 12345493 (Canadian P/N 10953488) or equivalent to the screw threads.
Tighten
5 N·m (44 lb in) |
