Caution: Refer to Brake Dust Caution in the Preface section.

Preliminary Procedures

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the brake rotor. Refer to Rear Brake Rotor Replacement.
3. Disconnect the park brake cable from the actuator.

1

Park Brake Shoe Retaining Clip Bolt (Qty: 2)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
15 N·m (11 lb ft)

2

Park Brake Shoe Retaining Clip (Qty: 2)

3

Park Brake Shoe and Lining

Procedure

1. To remove and install the park brake shoe, place the open end of the park brake shoe over the axle flange and rotate it until the shoe has cleared the flange.
2. Apply a thin coat of high temperature silicone brake lubricant to the contact areas of the brake shoe and the backing plate.
3. Adjust the park brake. Refer to Park Brake Adjustment.

Caution: Refer to Brake Dust Caution in the Preface section.

Preliminary Procedures

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
3. Remove the rear brake rotor. Refer to Rear Brake Rotor Replacement.

1

Park Brake Shoe Adjuster Spring

2

Park Brake Shoe Adjuster

Procedure

Clean the threads and apply high temperature grease to the adjuster screw.

3

Park Brake Shoe Hold Down Spring (Qty: 2)

Procedure

Compress the spring and rotate ¼ turn to release.

4

Park Brake Shoe Hold Down Spring Pin (Qty: 2)

5

Park Brake Shoe Return Spring

6

Park Brake Shoe (Qty: 2)

Procedure

1. Use denatured alcohol to clean brake dust or grease from the park brake shoes and hardware.
2. If reinstalling the park brake shoes, note the location of the park brake shoes for installation.
3. Apply a small amount of high temperature silicone grease to the brake shoe and backing plate contact points.
4. After the installation is complete, adjust the park brake. Refer to Park Brake Adjustment.