Warning: Refer to SIR Warning in the Preface section.

Warning: In order to prevent accidental deployment and the risk of personal injury, do not dispose of an undeployed inflatable restraint seat belt pretensioner as normal shop waste. Undeployed seat belt pretensioners contain substances that could cause severe illness or personal injury if their sealed containers are damaged during disposal. Use the following deployment procedures to safely dispose of an undeployed seat belt pretensioner. Failure to observe the following disposal methods may be a violation of federal, state, or local laws.

Preliminary Procedure

1. Remove the driver seat. Refer to Front Seat Replacement - Bucket.
2. Remove the jack stowage cover. Refer to Jack Stowage Cover Replacement.
3. Remove the rear window lower trim. Refer to Rear Window Lower Garnish Molding Replacement.
4. Remove the rear inner panel carpet. Refer to Body Rear Inner Panel Carpet Replacement.

1

Front Center Seat Belt Anchor Plate Bolt

Caution: Refer to Fastener Caution in the Preface section.

Tighten
43 N·m (32 lb ft)

2

Front Center Seat Shoulder Belt Guide

3

Front Center Seat Belt Retractor Nut (Qty: 2)

Tip
Position carpet in order to access nuts.

Tighten
43 N·m (32 lb ft)

4

Front Center Seat Shoulder Belt Retractor Assembly

Tip
Disconnect electrical connector.