Introduction
A new auxiliary body control module (XBCM) must be programmed with the latest operating software and vehicle calibrations. Ensure that the following conditions exist in order to prepare for BCM programming:
| • | The battery is fully charged. |
| • | The ignition switch is in the ON position. |
| • | The data link connector (DLC) is accessible. |
| • | All disconnected modules and devices are connected. |
For some export vehicles the additional procedures below are designed to program the export body control module. Before you start, read these procedures carefully and completely.
Programming the XBCM
Important: The vehicle theft system may not operate properly if a replacement XBCM is not properly programmed.
Program the auxiliary body control module. Refer to Service Programming System (SPS) for more information.
Enabling the Inclination Sensor - Export
Perform auxiliary BCM special function "Enable inclination sensor".
Important: After programming, perform the following to avoid future misdiagnosis:
- Turn the ignition OFF for 10 seconds.
- Connect the scan tool to the data link connector.
- Turn the ignition ON, with the engine OFF.
- Use the scan tool in order to retrieve history DTCs from all modules.
- Clear all history DTCs.
