GM Service Manual Online
For 1990-2009 cars only

Object Number: 1837689  Size: MF

Callout

Component Name

Preliminary Procedures

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement.
  3. Remove the rear propeller shaft. Refer to One-Piece Propeller Shaft Replacement or Two-Piece Propeller Shaft Replacement.
  4. Remove the front propeller shaft. Refer to Front Propeller Shaft Replacement.
  5. Drain the fluid from the transfer case. Refer to Transfer Case Fluid Replacement.
  6. Disconnect the electrical connectors and remove the electrical harness from the transfer case.
  7. Disconnect the shift control rod from the transfer case. Refer to Transfer Case Control Rod Replacement.
  8. Remove the crossmember. Refer to Transmission Support Crossmember Replacement.
  9. Remove the transmission mount. Refer to Transmission Mount Replacement for the 4L60-E/4L65-E/4L70-E automatic transmission , or Transmission Mount Replacement for the 6L50/6L80/6L90 automatic transmission , or Transmission Mount Replacement for the Allison automatic transmission.

1

Transfer Case Nut

Caution: Refer to Fastener Caution in the Preface section.

Tighten
50 N·m (37 lb ft)

2

Fuel Line Bracket

3

Transfer Case

4

Transfer Case Gasket

Procedure

  1. Install a NEW gasket without the use of any type of sealant or lubricant.
  2. Apply GM /P/N 12345879 (Canadian P/N 10953511) or equivalent lubricant meeting GM Specification 9985830 to the input shaft splines.