Special Tools

Caution: When using the J 43276 Clutch Pilot Bearing Remover, always secure the J 43276-1 Clutch Pilot Bearing Remover tool body using a wrench. Do not allow the J 43276-1 tool body to rotate. Failing to do so causes damage to the J 43276-1 tool body.

Note: The flywheel spacer (if applicable) must be removed prior to clutch pilot bearing removal.

1. Remove the clutch assembly. Refer to Clutch Assembly Replacement.
2. Using J 43276 perform the following in order to remove the clutch pilot bearing:

2.1.	Install the J 43276-1 into the clutch pilot bearing.

2.2.	Using a wrench, secure the J 43276-1.

2.3.	Insert the J 43276-2 into the J 43276-1.

2.4.	Rotate the J 43276-2 clockwise into the J 43276-1 until the clutch pilot bearing is completely removed from the crankshaft.

2.5.	Rotate the J 43276-2 counterclockwise to remove the J 43276-2 from the J 43276-1.

2.6.	Remove the J 43276-1 from the tool body.




3. Discard the old clutch pilot bearing.

Note: The flywheel spacer (if applicable) must be removed prior to pilot bearing installation.

1. Install a 5/8 inch washer (1) onto the J 38836 or equivalent.
2. Install a NEW clutch pilot bearing (2) onto the tool.



3. Install the NEW clutch pilot bearing into the crankshaft using J 38836 .



4. Inspect the clutch pilot bearing for proper installation.
5. Install the clutch assembly. Refer to Clutch Assembly Replacement.