GM Service Manual Online
For 1990-2009 cars only

    Object Number: 317310  Size: SH
  1. Apply a 5 mm (0.197 in) wide and 25 mm (1.0 in) long bead of adhesive GM P/N 12346141 (Canadian P/N 10953433) or equivalent, to both the right and left sides of the engine front cover to engine block junction at the oil pan sealing surfaces.

  2. Object Number: 1563933  Size: SH
  3. Apply a 5 mm (0.197 in) wide and 25 mm (1.0 in) long bead of adhesive GM P/N 12346141 (Canadian P/N 10953433) or equivalent, to the entire crankshaft rear oil seal housing to engine block junction at the oil pan sealing surfaces.

  4. Object Number: 387757  Size: SH

    Note: Always install a NEW oil pan gasket.

    The oil pan gasket and oil pan must be installed and the fasteners tightened while the adhesive is still wet to the touch.

  5. Install the NEW oil pan gasket into the groove in the oil pan.

  6. Object Number: 330568  Size: SH

    Note: The oil pan alignment must always be flush or forward no more than 0.3 mm (0.011 in) from the rear face of the engine block.

  7. Install the oil pan onto the engine block.
  8. Press the oil pan gasket into the grooves of the engine front cover and crankshaft rear oil seal housing.

  9. Slide the oil pan back against a suitable straight edge.

  10. Object Number: 38496  Size: SH
  11. Install the oil pan bolts and nuts, but do not tighten.
  12. Measure the pan-to-transmission housing clearance using a feeler gage and a straight edge.
  13. Use a feeler gage to check the clearance between the oil pan-to-transmission housing measurement points. If the clearance exceeds 0.3 mm (0.011 in) at any of the 3 oil pan-to-transmission housing measurement points (1), then repeat the step until the oil pan-to-transmission housing clearance is within the specification. The oil pan must always be forward of the rear face of the engine block.

    Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 38481  Size: SH

    Caution: The alignment of the mating components is crucial. An offset greater than 0.30 mm (0.011 in) between the rear faces of the oil pan and block is not acceptable. Offsets greater than 0.30 mm (0.011 in) will affect the alignment between the engine assembly and the transmission. Mis-alignment of the engine assembly to the transmission can lead to internal and external damage to the engine assembly and/or transmission.

  14. Tighten the oil pan bolts and nuts in sequence (1-12). Tighten the oil pan bolts to 25 N·m (18 lb ft).
  15. Measure the clearance between the 3 oil pan-to-transmission housing measurement points in order to ensure proper alignment.

  16. Object Number: 188048  Size: SH
  17. Install a NEW oil pan drain plug seal, O-ring, onto the oil pan drain plug.
  18. Install the oil pan drain plug into the oil pan and tighten to 25 N·m (18 lb ft).