Rear Axle Lubricant Replacement 9.5 Inch LD Axle

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the drain plug.



3. Remove the fill plug.

Notice: Refer to Fastener Notice in the Preface section.




1. Install the drain plug.

Tighten
Tighten the drain plug to 33 N·m (24 lb ft).

2. Fill the rear drive axle.

•	Use the proper fluid, refer to Approximate Fluid Capacities .

•	For the proper capacity, refer to Fluid and Lubricant Recommendations .




3. Install the fill plug.

Tighten
Tighten the fill plug to 33 N·m (24 lb ft).

4. Lower the vehicle.

Rear Axle Lubricant Replacement 8.6 Inch Axle

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the fill plug.



3. Remove the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement .

1. Install the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement .
2. Fill the rear axle housing.

•	Use the proper fluid. Refer to Approximate Fluid Capacities .

•	For the correct capacity, refer to Fluid and Lubricant Recommendations .

Notice: Refer to Fastener Notice in the Preface section.




3. Install the fill plug.

Tighten
Tighten the fill plug to 33 N·m (24 lb ft).

Rear Axle Lubricant Replacement 10.5 Inch Axle

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .



2. Remove the rear axle fill plug.



3. Remove the rear axle drain plug.
4. Drain the lubricant into a suitable container.
5. Inspect the drain plug for excessive metal particle accumulation. This accumulation is symptomatic of extreme wear.
6. Clean the drain plug.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




1. Install the rear axle drain plug.

Tighten
Tighten the rear axle drain plug to 33 N·m (24 lb ft).

2. Fill the rear axle. Use the proper fluid. Refer to Approximate Fluid Capacities and Fluid and Lubricant Recommendations .



3. Install the rear axle fill plug.

Tighten
Tighten the rear axle fill plug to 33 N·m (24 lb ft).

4. Lower the vehicle.